This unnecessary pedal travel is removed and taken up by the height of the clutch pedal stop, helping to lock into place the clutch disengagement point higher up off the floor for more consistent. The vw clutch ~~~ subtopics related to operation of the clutch are addressed in the following - when the clutch pedal is depressed, its movement is transmitted by the cable to the clutch release lever. you should also replace the clutch throwout bearing in the bell housing if this hasn't been done for a few years.. How to replace a broken clutch cable on a 1978 vw bus: slide under the left rear wheel and find the clutch lever that holds the threaded adjustment end of the clutch cable and wing nut; bolt the clutch pedal back onto the lever that attaches to the pan; from the rear, pull the threaded adjusting end of the cable all the way up through the.
Pedal feel is soft till about halfway, will not shift with car running, and car pulls forward softly when clutch pedal is fully pressed in. what really floors me is that everything worked flawlessly before the install. new clutch problems when there were none before the install. vw vr6 r32?. Now, the rebuilt pedal assembly can be installed by attaching the clutch pedal to the cable hook. then the clutch pedal is pushed forward to the firewall and held there, while the pedal assembly base is positioned into the tunnel.. Installing the clutch cable to the newly designed clutch pedal shaft is a snap, just pull the clutch cable a few inches out of the tunnel and attach the clutch cable onto the locating pin, place the flat washer on, then tighten the nylock nut, and finally slide the pedal assembly back in the tunnel..
